Underground Fence Collar Not Working

Our underground dog fence is not working.

Underground fence collar not working.

The power light is on the loop indicator light is off and the fence transmitter loop alarm is sounding. If the test light flashes your collar is working and you should try check the following. At invisible fence brand we welcome your questions. The transmitter gets plugged into this and the wiring from outside to the transmitter goes through.

Electronics usually this consists of a transmitter that is typically mounted on a wall a receiver collar that the dog wears and sometimes a surge protector that is plugged into an outlet. What to do if an invisible fence is not working. Chances are your dog hears it just fine. Make sure the static correction level on the receiver collar is set at 2 or above.

That can be expensive. There are three components to dog fencing. An invisible fence is less expensive than traditional fences because you don t have to buy materials or hire someone to build the fence. This is not a fool proof evidence that the fence is not working.

Take a look at some of the troubleshooting questions other happy customers asked or call 866 804 1250. We have gotten calls that the collar is not working because the dog is not crying or whimpering when he gets too near the fence. The collar does not beep or shock. However if your invisible fence stops working you may have to call the company to troubleshoot.

The collar receiver is beeping but the dog is not responding to the stimulation. The dog wears a collar that contains a receiver. As a veterinarian i ve observed five common problems associated with invisible fences. If your receiver collar is not beeping or correcting your dog.

When the dog approaches the underground pet fence a warning beep goes off. Dogs put up with the shock when the reward is great enough. Troubleshooting your petsafe radio fence includes testing each of its components including the collar the boundary width the transmitter the underground wires and other electrical fixtures that can cause interference with your system. This does not indicate that your collar is not working only that you do not hear it.

The collar has to be held on top of the boundary wire to activate or it does not activate at the boundary at all. Check the fit of the receiver collar on your pet. I ve how do you detect a break in an invisible fence. Because they use a hidden wire that transmits a signal to a collar worn by.

Even at the highest settings the shock collar will not always stop highly motivated dogs from running past the boundary. Try troubleshooting problems with your invisible fence yourself. April 11 2011 at 2 21 pm wire wrapped around a 1 2 inch cylinder. Take the test light tool and place it on the receiver collar and walk out to the boundary of the containment system.